Table of Contents
Advertisement
U
SING THE
T
O PRINT A PAGE FROM THE
1 If it is not powered on already, power on the copier and allow it to warm up.
2 If it is not powered on already, power on the ColorPASS using the power button on the front
panel (see
3 Access the Info screen from the copier touch panel and make sure that Idle appears
(see
page
If Printing or RIPping appears, the ColorPASS is processing. You must wait until the system
finishes and reaches the Idle state.
4 Press the Functions button.
5 Press the Print Pages button, and then select the page that you want to print.
The ColorPASS sends the selected page(s) to the copier.
Network Status LEDs
Two LEDs next to the Ethernet connector indicate the network speed. When a data transfer
occurs between the ColorPASS and the network, the appropriate LED(s) blink to indicate
network activity. For additional network information, see Configuration and Setup, which is
part of the user documentation set.
Ethernet network port
(Upper RJ-45)
N
:
The Ethernet network cable at the customer site and the Command/Status Ethernet
OTE
Crossover cable included with the ColorPASS look similar, but are not interchangeable. Make
sure that you attach the Command/Status Ethernet Crossover cable to the lower RJ-45 port
and the network cable to the upper RJ-45 port on the ColorPASS back panel.
C
PASS
OLOR
P
P
RINT
AGES MENU
page
28) and allow it to start up completely (approximately three minutes).
35).
Network link speed
LED 2
10 Megabits/second
100 Megabits/second
LED 1
1000 Megabits/second
LED 1
LED 2
Off
Green
Green
Green
Amber
Green
40
Advertisement
Table of Contents
