S
P
ERVICE
ROCEDURES
9 If you replaced the hard disk drive with a new hard disk drive, install system software (see
page
104).
Troubleshooting tips:
• Following system software installation, if the ColorPASS boots up much slower than usual,
clear the CMOS as follows:
– Make sure that the power cable is removed from the power outlet, and then remove the
battery (see
page
– Wait two minutes to allow the motherboard electrical components to fully discharge.
– Reinstall the battery.
– After reassembling the system, reset the time and date in Setup (see Configuration and
Setup, which is part of the user documentation set).
• If a startup error displays on the Control Panel when you power on the ColorPASS, check
the connections.
10 Verify functionality (see
82).
page
103).
95