Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
Entering Service Mode
Use the following procedure to verify that the system functions properly after installing a new
motherboard.
T
S
M
O ENTER
ERVICE
ODE AND VERIFY THE SYSTEM
This procedure assumes that the ColorPASS is powered off, no media is in the DVD
N
:
OTE
drive, you have installed a new motherboard, and that you have reassembled the ColorPASS
and attached external cables.
N
:
Do not insert the Fiery Options Utility DVD into the DVD drive yet. You will install
OTE
the Fiery Options Utility DVD when you are ready to transfer options to the new
motherboard
(page
1 Make sure the ColorPASS is connected to the copier (see
2 Locate the one-time use dongle provided with the new motherboard and connect it to a USB
port on the front or back panel.
3 Remove all dongles (such as for SeeQuence Impose or Compose) and USB devices (except for
the keyboard and mouse, if present) that may be currently connected to any other USB port.
Reconnect other dongles and USB devices only after you verify that the ColorPASS starts up
successfully in Service Mode.
Connecting the dongle
F
23:
IGURE
71), after you verify the system in Service Mode.
One-time use
dongle
Connect to an
available USB port
page
28).
70
Advertisement
Table of Contents
