Table of Contents
Advertisement
I
NSTALLATION
Completing installation and starting up
To finish the installation of the ColorPASS at the customer site, make sure to do
the following:
1 Make sure that the copier is powered on.
2 Power on the ColorPASS (see
Make sure that the power cord is attached and that the power switch on the back panel is in
the ON position. Press the power button on the front panel once and release the button. The
power supply automatically senses the correct voltage.
3 Wait for the ColorPASS to power on and for the Info screen to display Idle on the copier touch
panel:
The ColorPASS takes approximately two minutes to power on and display Idle on the Info
screen of the copier touch panel.
While the ColorPASS is booting, the following message displays on the copier touch panel:
"Wait a while. (Check the power source of the print server behind the main unit and cable
connection if the display does not change in a moment.)" If the message remains for longer
than two minutes, verify that the copier interface cable is connected correctly to the copier.
4 Perform any required system software upgrades.
For instructions, see the documentation that accompanies the ColorPASS service upgrade.
Updates to Fiery Server Software may be available for the ColorPASS from a variety of sources
(for example, System Updates (see
downloaded by the customer).
Windows operating system updates should be obtained from Microsoft directly. Because such
updates are available directly from Microsoft, EFI does not maintain or provide them via the
System Updates feature.
5 Print a Test Page and a Configuration page and ask the customer to verify the output.
6 If the ColorPASS requires a static IP address (for example, in a non-DHCP network
environment), work with the network administrator to configure it as described on
7 Ask the network administrator to perform Setup and to print some test documents over
the network.
8 Store the output and the current Configuration page(s) near the copier.
9 Inform the site administrator that the ColorPASS user software must be installed on
networked computers that print to the ColorPASS.
10 Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the
ColorPASS is stored in a safe location, accessible to you.
page
28).
page
110), patches provided on CD, or patches
31
page
31.
Advertisement
Table of Contents
