EAS30315
CHECKING THE V-BELT
1. Check:
• V-belt "1"
Cracks/damage/wear Replace.
Grease/oil Clean the primary and second-
ary sheave.
2. Measure:
• V-belt width "a"
Out of specification Replace.
TIP
Measure the V-belt width as illustration.
V-belt width limit
31.4 mm (1.24 in)
a
2. Plastic board
3. Ruler
EAS30316
CHECKING THE PRIMARY SHEAVE
1. Check:
• Primary sliding sheave
• Primary fixed sheave
Cracks/damage/wear Replace the primary
sliding sheave and primary fixed sheave as a
set.
EAS31436
CHECKING THE V-BELT CASE AIR DUCT
1. Check:
• V-belt case air duct
Cracks/damage Replace.
V-BELT AUTOMATIC TRANSMISSION
2
1
3
5-44
EAS30317
CHECKING THE PRIMARY SHEAVE
WEIGHTS
The following procedure applies to all of the pri-
mary sheave weights.
1. Check:
• Primary sheave weight
Cracks/damage/wear Replace.
2. Measure:
• Primary sheave weight outside diameter
Out of specification Replace.
Weight outside diameter
25.0 mm (0.98 in)
Limit
24.5 mm (0.96 in)
EAS30318
CHECKING THE SLIDERS
The following procedure applies to all of the slid-
ers.
1. Check:
• Slider
Cracks/damage/wear Replace.
EAS30319
CHECKING THE SECONDARY SHEAVE
1. Check:
• Secondary fixed sheave
• Secondary sliding sheave
Cracks/damage/wear Replace the sec-
ondary fixed and sliding sheaves as a set.
2. Check:
• Torque cam groove "1"
Damage/wear Replace the secondary
fixed and sliding sheaves as a set.
3. Check:
• Guide pin "2"
Damage/wear Replace the secondary
fixed and sliding sheaves as a set.