Assembling The Rear Brake Lock Caliper - Yamaha TMAX 2020 Service Manual

EAS31421
ASSEMBLING THE REAR BRAKE LOCK
CALIPER
1. Install:
• Slide pin bolt "1"
(to the rear brake lock caliper bracket)
Rear brake lock caliper slide pin
bolt
17 N·m (1.7 kgf·m, 13 lb·ft)
Recommended lubricant
Silicone grease
2. Install:
• Rear brake lock caliper bracket
Rear brake lock caliper bracket
bolt
22 N·m (2.2 kgf·m, 16 lb·ft)
LOCTITE®
3. Install:
• Boot "1"
• Sleeve "2"
Recommended lubricant
Silicone grease
4. Install:
• Boot "1"
5. Install:
• Shaft L "1"
• Piston adjusting bolt "2"
• Locknut "3"
Recommended lubricant
Silicone grease
Rear brake lock caliper piston
locknut
22 N·m (2.2 kgf·m, 16 lb·ft)
Left-hand thread
6. Adjust:
• Piston adjusting bolt
a. Tighten shaft L manually until it touches the
locknut.
b. With shaft L fastened, turn and adjust the
piston adjusting bolt so that the length "a"
between the end of shaft L and the end of
the piston adjusting bolt is changed to 19
mm (0.75 in).
4-65
REAR BRAKE