Checking And Adjusting The Steering Head - Yamaha TMAX 2020 Service Manual

6. Use a suitable grease gun (commercially
available) to inject YAMAHA GREASE "J"
(Shell Alvania EP Grease R0®) into the hole
"a" in the tip of the drive axle. Continue inject-
ing until the YAMAHA GREASE "J" (Shell Al-
vania EP Grease R0®) comes out of the side
holes "b" on the drive axle.
TIP
Place a rag under the drive axle so the grease
does not get on other parts.
7. Lubricate:
• Drive pulley assembly inner part "a"
Recommended lubricant
YAMAHA GREASE "J" (Shell
Alvania EP Grease R0®)
38g
a
a
b
b
a
PERIODIC MAINTENANCE
ECA27020
NOTICE
If you put in too much grease, the grease will
come out of the holder, which could cause
grease to get on the drive belt.
TIP
Use a scale to weigh the grease, and inject 38 g
into the drive pulley assembly inner part.
8. Install:
• All removed part
9. Adjust:
• Drive belt tension
Refer to "DRIVE BELT TENSION" on page 3-
21.
EAS30645
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on the centerstand so that the
front wheel is elevated.
3-23
a