Yamaha TMAX 2020 Service Manual page 71

1. Rear frame
2. Rear brake hose (hydraulic unit to rear
brake caliper)
3. Rear brake lock cable
4. Electrical components tray
5. Guide
6. Footrest bracket
7. Frame
8. Plastic locking tie
9. Clamp
10. Rear wheel sensor lead
11. Fuel tank bracket
12. Cable guide
A. Install the bracket with the rotation stopper
in contact with the rib of the rear frame.
B. Fasten the protector portion of the rear
brake hose and the protector portion of the
rear wheel sensor lead with the plastic
locking tie, so their protectors overlap, near
the end of the rear brake hose. Use the
edge of the protectors as a guide (so they
are fastened within a range of 0–10 mm
(0–0.39 in) from their ends). Make sure the
plastic locking tie does not detach from the
brake hose protector and the rear wheel
sensor lead.
C. Route the rear brake lock cable in front of
the section where the electrical compo-
nents tray and frame are fastened.
D. Route the rear brake hose along the guide
of the electrical components tray.
E. Make sure there is no slack in the rear
wheel sensor lead within this interval.
F. Arrange the rear wheel sensor lead either
on top of, below, or outside the rear brake
hose.
G. The end of the plastic locking tie should
face downward without being cut.
H. The opening of the clamp should face the
top.
I. The opening of the clamp should face the
right.
J. Route the rear brake lock cable between
the rear frame and the rear brake hose.
K. Fasten the grommet portion of the rear
brake lock cable with the cable guide.
L. Fasten the rear brake hose and white tape
section of the rear wheel sensor lead with
the clamp. Fasten the brake hose and rear
wheel sensor lead so that the rear wheel
sensor lead is located on the right side.
M. The rear brake lock cable passes between
the frame and the rear brake hose (hydrau-
lic unit to rear brake caliper).
2-42
CABLE ROUTING