Lines short circuit check "B"
Accelerator position sensor coupler "1"
ECU coupler "2"
A
1
W B/L L R
Is resistance ?
YES
Go to step 4.
NO
a. Replace the wire harness.
b. Push the ON/start switch, and then check the condition of the DTC using the malfunction mode
of the YDT.
Is it in the "Recovered" condition?
YES
Go to step 6, and complete the service.
NO
Go to step 4.
4. Defective accelerator position sensor.
• Execute the diagnostic mode. (Code D14) (Accelerator position sensor signal 1.)
When the throttle valves are fully closed
When the throttle valves are fully open
• Execute the diagnostic mode. (Code D15) (Accelerator position sensor signal 2.)
When the throttle valves are fully closed
When the throttle valves are fully open
P2122, P2123, P2127, P2128, P2138
[P2122, P2123, P2127, P2128, P2138]
white–any other coupler terminal
[P2123, P2128] black/blue–any other coupler
terminal
[P2122, P2127] blue–any other coupler terminal
[P2122, P2123, P2127, P2128, P2138] red–any
other coupler terminal
[P2122, P2123, P2127, P2128, P2138]
white–any other coupler terminal
[P2123, P2128] black/blue–any other coupler
terminal
[P2122, P2127] blue–any other coupler terminal
[P2122, P2123, P2127, P2128, P2138] red–any
other coupler terminal
B
1
W B/L L R
9-160
2
L
Lg
L
Y/R
R/W
W
W
B/L
R
B/L
Lg
B
11–20
95–106
9–23
93–109