Table of Contents
Advertisement
Is resistance ?
YES
Go to step 5.
NO
a. Replace the wire harness.
b. Push the ON/start switch, and then check the condition of the DTC using the malfunction mode
of the YDT.
Is it in the "Recovered" condition?
YES
Go to step 7, and complete the service.
NO
Go to step 5.
5. Defective O
sensor.
2
• Check the O
sensor.
2
Refer to "ENGINE REMOVAL" on page 5-7.
Is check result OK?
YES
Go to step 6.
NO
a. Replace the O
Refer to "ENGINE REMOVAL" on page 5-7.
b. Push the ON/start switch, and then check the condition of the DTC using the malfunction mode
of the YDT.
Is it in the "Recovered" condition?
YES
Go to step 7, and complete the service.
NO
Go to step 6.
6. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to "REPLACING THE ECU (Engine Control Unit)" on page 8-93.
7. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of "Recovered" using the YDT, and then delete the DTC.
sensor.
2
9-97
P0132
Advertisement
Chapters
Table of Contents
Troubleshooting
