Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
G088897
4. Check:
• Wheel bearing
Front wheel turns roughly or is loose
Replace the wheel bearings.
• Oil seal
Damage/wear Replace.
EAS30151
ASSEMBLING THE FRONT WHEEL
ECA21340
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearing
New
• Oil seal
New
a. Install the new wheel bearing (right side).
ECA18110
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
2
1 1
G088898
b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
G088899
d. Install the new oil seals.
2. Install:
• Front wheel sensor rotor
Wheel sensor rotor bolt
8 N·m (0.8 kgf·m, 5.9 lb·ft)
LOCTITE®
ECA17200
NOTICE
Replace the wheel sensor rotor bolts with
new ones.
TIP
Install the wheel sensor rotor with the stamped
mark "1" facing outward.
4-25
FRONT WHEEL