Yamaha TMAX 2020 Service Manual page 55

1. Stator coil coupler
2. Turn signal/hazard relay
3. Radiator fan motor relay
4. Seat heater relay (power) (for XP560D)
5. Seat heater relay (control) (for XP560D)
6. Windshield drive unit relay (down)
(for XP560D)
7. Windshield drive unit relay (up)
(for XP560D)
8. Tail/brake light lead (left)
9. Crankshaft position sensor coupler
10. Stator coil assembly lead
11. Clamp
12. Mudguard assembly
13. Tail/brake light cover
14. Wire harness
15. Rear frame
A. Connect the rear turn signal light lead by
matching the colors of the coupler (left:
black, right: white). Connect the license
plate light lead (blue/black). (Color does
not matter.) Connect the seat heater lead.
(for XP560D)
B. The order of arrangement of the lead does
not matter as long as it is installed within
this range.
C. Install the plastic locking tie within this
range.
D. Fasten the tape portion of each lead with
the clamp.
White tape: Wire harness, seat heater lead
(for XP560D)
Yellow tape: Mudguard assembly lead It
should be okay as long as the clamp is
aligned roughly to the tape section of each
lead.
E. The end of the plastic locking tie should
face the inside without being cut.
F. Route the rear turn signal light lead (left/
right) and license plate light lead through
the hole in the tail/brake light cover.
G. Adjust the stator coil assembly lead and
wire harness to the position of the wire har-
ness clamp and fasten them with the plas-
tic locking tie. Cut the tip and face it outside
the vehicle.
H. Install the wire harness clamp into the hole
in the rear frame.
2-26
CABLE ROUTING