Yamaha TMAX 2020 Service Manual page 79

1. Canister bracket
2. Canister holder
3. Canister
4. Fuel tank breather hose (rollover valve to
canister)
5. Rollover valve
6. Fuel tank breather hose (fuel tank to roll-
over valve)
7. Fuel tank
8. Throttle body assembly
9. Canister purge hose (hose joint to canis-
ter)
10. Clamp
A. Insert the canister holder into the hook on
the canister bracket.
B. Install the canister holder and canister with
the marks facing the top.
C. To canister
D. Install the canister purge hose with the
white paint mark facing rearward.
E. 5–7 mm (0.20–0.28 in)
F. Make sure the clip does not ride on top of
the bulge in the hose mounting area.
G. Insert the canister purge hose until it butts
against the throttle body assembly.
H. Do not allow the bolt head of the clamp
that is holding the throttle body joint to
touch the clip of the canister purge hose.
I. The end of the clip should face downward.
(2 pieces)
J. Face the tip of the clip knob toward the
back of the vehicle so it does not interfere
with other parts.
K. Do not allow the knob on the clip to touch
the throttle body.
L. The end of the clip should face the outside.
M. Do not allow the knob of the clip to extend
outside further than the wavy line in the
illustration.
N. Clip knob on back side of vehicle
O. Tip of fuel tank breather hose (fuel tank to
rollover valve)
P. 90 
Q. Insert the tip of the fuel tank breather hose
(fuel tank to rollover valve) within this
range.
2-50
CABLE ROUTING