Yamaha TMAX 2020 Service Manual page 75

1. Fuel tank breather hose (fuel tank to roll-
over valve)
2. Fuel tank
3. Clamp
4. Rear brake hose (hydraulic unit to rear
brake caliper)
5. Fuel tank breather hose (rollover valve to
canister)
6. Rollover valve
7. Canister
8. Canister breather hose
9. Canister purge hose (hose joint to canis-
ter)
10. Clip
11. Bracket
A. Install the fuel tank breather hose (rollover
valve to canister) with the mark facing the
outside. Align the mark on the hose with
the back end of the clamp.
B. Fasten the rear brake hose and fuel tank
breather hose with the clamp. Install the
clamp with the longer side of the fixed sec-
tion facing downward, and adjust the posi-
tion so that the intersection of the rear
brake hose and fuel tank breather hose is
in contact with the clamp.
C. To hose joint
D. Install the fuel tank breather hose with the
mark facing the outside. The end of the
fuel tank breather hose should come into
contact with the rollover valve.
E. The end of the clip should face downward.
Make sure the clip does not ride on top of
the bulge in the hose installing area.
F. Route the fuel tank breather hose and can-
ister purge hose on the inside of the guide
section of the bracket.
G. Assemble up to the round end of the canis-
ter.
2-46
CABLE ROUTING