Yamaha TMAX 2020 Service Manual page 208

b
a
4. Install:
• Front brake master cylinder assembly
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-47.
5. Install:
• Handlebar switch holder
• Handlebar switch (left)
Handlebar switch holder screw
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
Handlebar switch screw (left)
1.8 N·m (0.18 kgf·m, 1.3 lb·ft)
TIP
Align the projection "a" on the handlebar switch
(left) with the hole "b" in the handlebar.
6. Lubricate:
• Rear brake lock cable
(to cable end)
Recommended lubricant
YAMAHA GREASE "F"
1
2
c
b
a
7. Connect:
• Rear brake lock cable
(to rear brake lock lever)
TIP
Rotate the lever to the position "a", and then in-
stall the rear brake lock cable.
8. Install:
• Rear brake master cylinder assembly
Refer to "INSTALLING THE REAR BRAKE
MASTER CYLINDER" on page 4-62.
9. Install:
• Handlebar grip
• Grip end "1"
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
a
1
G088918
4-79
HANDLEBAR
a