Yamaha TMAX 2020 Service Manual page 173

1. Remove:
• Brake pad clip "1"
• Brake pad pin "2"
• Brake pad spring
2
2. Remove:
• Brake pad "1"
3. Measure:
• Brake pad wear limit "a"
Out of specification  Replace the brake
pads as a set.
Brake pad lining thickness limit
0.5 mm (0.02 in)
4. Remove:
• Brake caliper bolt
5. Install:
• Brake pad
• Brake pad spring
TIP
Always install new brake pads and new brake
pad spring as a set.
a. Connect a clear plastic hose "1" tightly to
the bleed screw "2". Put the other end of the
hose into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
2
1
c. Tighten the bleed screw.
1
d. Install the brake pads and brake pad spring.
TIP
The arrow mark "a" on the brake pad spring
must point in the direction of disc rotation.
6. Install:
• Brake pad pin
• Brake pad clip
• Front brake caliper
7. Check:
• Brake fluid level
Below the minimum level mark  Add the
specified brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-14.
4-44
FRONT BRAKE
Brake caliper bleed screw
6 N·m (0.6 kgf·m, 4.4 lb·ft)
Front brake caliper bolt
35 N·m (3.5 kgf·m, 26 lb·ft)
1