Yamaha TMAX 2020 Service Manual page 43

1. Handlebar switch coupler 1 (left) (black)
2. Front brake light switch coupler (black)
(for XP560D)
3. Rear brake light switch coupler (white)
(for XP560D)
4. Handlebar switch coupler 2 (right) (white)
5. Handlebar switch lead (left/right)/Grip
warmer lead (left/right) (for XP560D)/Front
brake light switch lead (for XP560D)/Rear
brake light switch lead (for XP560D)
6. Wire harness (accelerator position sensor
lead)
7. Positive battery lead
8. Headlight bracket
9. Plastic locking tie
10. Wire harness
11. Handlebar switch coupler (right) (white)
12. Handlebar switch coupler (left) (white)
13. Electrical components tray
14. Grip warmer lead (left/right) (for XP560D)/
Front brake light switch lead (for XP560D)/
Rear brake light switch lead (for XP560D)
A. Arrange the front wheel sensor coupler in
front of the wire harness.
B. Lead going to meter assembly
C. To front wheel sensor
D. Handlebar switch coupler 1 (left) (black),
handlebar switch coupler 1 (right), handle-
bar switch coupler 2 (right) (white), handle-
bar switch coupler 3 (left) (white), rear
brake light switch coupler (white)
(for XP560D), front brake light switch cou-
pler (black) (for XP560D), handlebar switch
coupler 3 (right) (black) (for XP560E), han-
dlebar switch coupler 4 (left) (white)
(for XP560E).
The order of arrangement of the coupler
above does not matter.
E. Refer to "Handlebar (top and left side view)
(for XP560D)" or "Handlebar (front view)
(for XP560D)".
F. Route the end of the positive battery lead
(before the taped section at the bottom) so
that it does not go between the wire har-
ness and the headlight bracket.
G. Install the clamp to the headlight bracket.
H. Fasten the headlight bracket and the white
tape section of the wire harness with the
plastic locking tie. The end of the plastic
locking tie should face upward without
being cut.
I. Route the handlebar switch lead (left/right)
on the inside of the windshield drive unit
cable.
J. Install the wire harness coupler into the
hole on the electrical components tray.
K. Pass the plastic locking tie through the
hole of the electrical components tray and
fasten the white tape section of the lead.
The end of the plastic locking tie should
face downward without being cut.
2-14
CABLE ROUTING