• Center cover
Refer to"GENERAL CHASSIS (2)" on
page 4-11.
• Bottom center cowling
• Side panel
• Bottom side cowling
Refer to "GENERAL CHASSIS (1)" on
page 4-1.
EAS30625
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the ex-
haust pipes and gaskets.
1. Remove:
• Bottom side cowling
• Side panel
• Bottom center cowling
Refer to "GENERAL CHASSIS (1)" on
page 4-1.
• Center cover
• Fuel tank cover assembly
• Side cover (right)
• Rear side cowling assembly (right)
• Footboard (right)
Refer to "GENERAL CHASSIS (2)" on
page 4-11.
2. Check:
• Exhaust assembly "1"
Cracks/damage Replace.
• Gasket "2"
Exhaust gas leaks Replace.
3. Check:
Tightening torque
• Exhaust pipe nut "3"
• Exhaust assembly nut (front) "4"
• Exhaust assembly nut (rear) "5"
Exhaust pipe nut
20 N·m (2.0 kgf·m, 15 lb·ft)
Exhaust assembly nut (front)
55 N·m (5.5 kgf·m, 41 lb·ft)
Exhaust assembly nut (rear)
31 N·m (3.1 kgf·m, 23 lb·ft)
PERIODIC MAINTENANCE
4. Install:
• Footboard (right)
• Rear side cowling assembly (right)
• Side cover (right)
• Fuel tank cover assembly
• Center cover
Refer to "GENERAL CHASSIS (2)" on
page 4-11.
• Bottom center cowling
• Side panel
• Bottom side cowling
Refer to "GENERAL CHASSIS (1)" on
page 4-1.
EAS30623
CHECKING THE CYLINDER HEAD
BREATHER HOSE
1. Remove:
• Bottom side cowling
• Side panel
• Bottom center cowling
Refer to "GENERAL CHASSIS (1)" on
page 4-1.
• Center cover
• Fuel tank cover assembly
• Side cover (right)
• Rear side cowling assembly (right)
• Footboard (right)
Refer to "GENERAL CHASSIS (2)" on
page 4-11.
2. Check:
• Cylinder head breather hose "1"
Cracks/damage Replace.
Loose connection Connect properly.
ECA14920
NOTICE
Make sure the cylinder head breather hose is
routed correctly.
3. Install:
• All removed part
3-11