Is that value increased?
YES
Go to step 7.
NO
Go to step 6.
6. Malfunction in ABS ECU.
• Replace the ABS ECU and go to step 7
7. Delete the DTC and check that the MIL goes off.
• Push the ON/start switch, and then rotate the rear wheel by hand.
• Start the engine, and input the vehicle speed signals by operating the vehicle at 20 to 30 km/h
(12 to 19 mph).
• Confirm that the DTC has a condition of "Recovered" using the malfunction mode of the YDT, and
then delete the DTC. Delete this DTC even if it has a condition of "Detected".
9-118
P0500