EAS20552
30_EVENT
EAS33033
TROUBLESHOOTING
Item
Latch up detected.
Fail-safe system
• Unable to start engine
• Unable to drive vehicle
Procedure
1. The vehicle has overturned.
• Raise the overturned vehicle vertically and check again.
• Push the ON/start switch, then push the OFF/LOCK switch, and then push the ON/start switch.
Is the MIL on?
YES
Go to step 2.
NO
Service is completed.
2. Installed condition of lean angle sensor.
• Check the installed direction and condition of the sensor.
Is check result OK?
YES
Go to step 3.
NO
a. Fix the lean angle sensor installation condition.
b. Push the ON/start switch, then push the OFF/LOCK switch, and then push the ON/start switch.
Is the MIL on?
YES
Go to step 3.
NO
Service is completed.
3. Defective lean angle sensor.
• Execute the diagnostic mode. (Code D08)
• Check the lean angle sensor output voltage.
Upright
Overturned
Is check result OK?
YES
Go to step 4.
NO
a. Replace the lean angle sensor.
b. Push the ON/start switch, then push the OFF/LOCK switch, and then push the ON/start switch.
0.4–1.4 V
3.7–4.4 V
9-66
30_EVENT