Yamaha TMAX 2020 Service Manual page 61

1. Rear brake lock cable
2. Handlebar cover
3. Throttle cable (decelerator cable)
4. Throttle cable (accelerator cable)
5. Rear brake lock lever
6. Front brake hose (front brake master cylin-
der to hydraulic unit)
7. Front brake master cylinder
8. Throttle grip
9. Handlebar switch (right)
10. Handlebar switch (left)
11. Handlebar grip
12. Rear brake master cylinder
13. Rear brake hose (rear brake master cylin-
der to hydraulic unit)
14. Wire harness
15. Brake hose holder
A. Route the rear brake lock cable through
the hole in the handlebar cover.
B. Route through the cable guide in the order
of the throttle cable (decelerator cable) fol-
lowed by throttle cable (accelerator cable).
C. Turn the rear brake lock lever up to the
position shown in the illustration before
installing the rear brake lock cable.
D. Route the handlebar switch lead (right) on
top of and at the back of the handlebar.
E. Route the handlebar switch lead (left) on
top of and at the back of the handlebar.
F. The opening of the clamp should face the
front.
G. Insert the projection on the brake hose
holder into the hole on the lower bracket to
assemble it.
2-32
CABLE ROUTING