Installing The Rear Shock Absorber Assembly - Yamaha TMAX 2020 Service Manual

TIP
• When installing the oil seals "2" to the relay
arm, face the character stamp of the oil seals
outside.
• Press in the oil seal so it does not protrude
from the end surface of the relay arm.
• Install the connecting arm so that the stamp
mark "B67" is facing outward. The stamp mark
can be facing either up or down.
5 1
3 2
4 1
2
1
3. Relay arm
4. Connecting arm
5. Rear shock absorber assembly
A. Left side
B. Right side
TIP
• Install the rear shock absorber assembly upper
bolt and connecting arm bolt from the left.
• Install the relay arm so that stamped mark "a"
is positioned as shown in the illustration.
• Install the rear shock absorber assembly so
that the label is facing downward.
• Install the rear shock absorber assembly so
that the rebound damping adjusting screw "b"
is facing downward. (for XP560D)
REAR SHOCK ABSORBER ASSEMBLY
a
c
5
b
c
1 4
2
c
a
EAS30225
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY
1. Install:
• Rear shock absorber assembly
TIP
• Install the rear shock absorber assembly lower
bolt and relay arm bolt from the right.
• Install the rear shock absorber assembly with
the swingarm down.
2. Tighten:
• Rear shock absorber assembly lower nut
• Relay arm nut
Rear shock absorber assembly
lower nut
75 N·m (7.5 kgf·m, 55 lb·ft)
Relay arm nut
50 N·m (5.0 kgf·m, 37 lb·ft)
4-99
a
b