Yamaha TMAX 2020 Service Manual page 53

1. Centerstand lock solenoid lead
2. Sidestand switch
3. Starter motor lead
4. Footboard
5. Joint coupler lead
6. Wire harness (seat/fuel lid lock solenoid
lead)
7. Rear frame
8. Wire harness
9. AC magneto lead
10. Centerstand lock solenoid cover
11. Sidestand switch lead
A. Install the wire harness clamp into the hole
on the fuel tank bracket.
B. Install the plastic locking tie so that the
centerstand lock solenoid lead does not go
slack in the space between the center-
stand lock solenoid coupler and the guide
of the generator cover protector.
C. Install the plastic locking tie within this
range.
D. Make sure that the centerstand lock sole-
noid lead does not slacken in this range.
E. Install the centerstand lock solenoid lead to
the rib of the generator cover protector.
(3 locations)
F. Anti-theft alarm coupler (no connection)
G. Install the clamp of the sidestand switch
lead to the bracket.
H. Fasten the wire harness to the footboard
with the plastic locking tie. Position the
plastic locking tie within the range shown in
the illustration. Point the end of the plastic
locking tie rearward and place it inside of
the footboard.
I. Assemble the wire harness clamp to the
round area of the rib.
J. Install the plastic locking tie between the
wire harness clamp and the centerstand
lock solenoid coupler. Make sure the plas-
tic locking tie does not come into contact
with the bare wire. The end of the plastic
locking tie should face downward without
being cut.
K. Fasten the white tape section of the starter
motor lead with the plastic locking tie.
L. The end of the plastic locking tie should
face the inside without being cut.
M. Fasten the white tape section of the AC
magneto lead with the plastic locking tie.
The plastic locking tie should face outside
with the end cut.
N. Connect the fuel pump coupler securely to
the fuel pump.
O. Route the seat/fuel lid lock solenoid lead
through the rib portion of the filler cover.
P. Route the centerstand lock solenoid lead
through the notch section of the center-
stand lock solenoid cover.
Q. Fasten the sidestand switch lead to the
footboard with the plastic locking tie. Point
the end of the plastic locking tie rearward
and place it inside of the footboard.
R. Install the wire harness clamp into the hole
in the rear frame.
2-24
CABLE ROUTING