Install A Replacement Fan Tray - NETGEAR 8800 Series Hardware Installation Manual

8800 Series Chassis Switch Hardware Installation Guide
WARNING!
Be sure that all fan blade motion has ceased before continuing to
remove the fan tray.
Support the bottom of the fan tray with your free hand as you use the handle to slide the fan
5.
tray completely out from the fan tray slot.
CAUTION:
Be sure that both hands are used to support the weight of the fan tray
during removal.
Leave the ESD-preventive wrist strap permanently connected to the
Note:
switch so that it is always available when you need to touch
ESD-sensitive components.

Install a Replacement Fan Tray

To install the replacement fan tray:
Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle on the top left corner of the switch.
Support the bottom of the fan tray with one hand as you lift the fan tray by the handle using
2.
the other hand. Align the spare fan tray with the fan tray slot on the switch, and then slide
the fan tray into place in the switch (see
CAUTION:
Always use both hands to support the weight of the fan tray during
installation.
and
Figure 65
Chapter 11. Replace 8800 Series Chassis Components
Figure 66).
| 95