Table of Contents
Advertisement
AC Power Cord Retainer for the XCM8810 Chassis 10-slot
Connect all AC power cords before you install the power cord retainer.
You need the following tools and equipment to install or remove the AC power cord retainer:
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
Install the Power Cord Retainer
To install the power cord retainer:
Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle on the top-left corner of the XCM8810 chassis.
Locate the power outlets on the front of the switch.
2.
Figure 49. Power outlets on the XCM8810 Switch
Connect each AC power cord to a power outlet on the switch as shown in the following
3.
figure.
Figure 50. Connecting an AC power cord to the XCM8810 Switch
82 |
Chapter 9. AC Power Cord Retainers
8800 Series Chassis Switch Hardware Installation Guide
Advertisement
Table of Contents
