Step 4: Install The Switch; Mount The Switch In A Rack - NETGEAR GS728TPv3 Hardware Installation Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports
4. Verify that the package contains the following items:
a. Switch
b. Power cord
c. Brackets for rack mounting
d. Screws for rack mounting
e. Rubber footpads for tabletop installation
f. Rubber protection caps, which are already installed in the SFP sockets. If you
install an SFP transceiver module, you must remove the cap from the SFP socket.
g. Installation guide
If any item is missing or damaged, contact your local NETGEAR reseller for replacement.

Step 4: Install the switch

You can install the switch in a standard 19-inch (48.26-centimeter) network equipment
rack or on a flat surface.

Mount the switch in a rack

To install the switch in a rack, you need the rack-mount brackets and screws supplied
with the switch.
To install the switch in a rack:
1. Attach the supplied mounting brackets to the side of the switch.
2. Insert the screws provided in the product package through each bracket and into
the bracket mounting holes in the switch.
3. Tighten the screws with a No. 2 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two
pan-head screws with nylon washers through each bracket and into the rack.
5. Tighten the screws with a No. 2 Phillips screwdriver to secure the mounting brackets
to the rack.
Installation 29 Hardware Installation Guide