Table of Contents
Advertisement
Loosen the captive screw at each end of the blank front panel, using a #2 Phillips
2.
screwdriver.
Figure 39. Captive screw on a blank front panel
Remove the blank front panel from the front of the switch.
3.
Figure 40. Removing a blank front panel from a 8800 series switch
Install an I/O module or Supervisory module in the open slot as described in
4.
XCM8000 Series Module
Leave the ESD-preventive wrist strap permanently connected to the
Note:
switch, so that the strap is always available when you need to
handle ESD-sensitive components.
70 |
Chapter 7. Install Modules and Establish Initial Management Access
8800 Series Chassis Switch Hardware Installation Guide
on page 62.
Install an
Advertisement
Table of Contents
