Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
(Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4)
and require isolation from the exposed OSP cabling. The addition
of Primary Protectors is not sufficient protection in order to
connect these interfaces metallically to OSP wiring.
PoE Devices
When connecting power over Ethernet (PoE) devices to a PoE-capable I/O module, all
connections between the PoE device and the module have to be inside the same building
and use a low-voltage power distribution system per IEEE 802.3af.
Battery Replacement and Disposal
Batteries included with your products are encapsulated and have to be replaced by qualified
service personnel only. Contact your NETGEAR service personnel for product replacement.
Do not attempt to replace the battery. If these instructions are disregarded and replacement
of these batteries is attempted, the following guidelines need to be followed to avoid danger
of explosion:
Replace with same or equivalent battery type as recommended by the battery
1.
manufacturer.
Dispose of battery in accordance with the battery manufacturer's recommendation.
2.
Fiber Optic Ports—Optical Safety
The following safety warnings apply to all optical devices used in NETGEAR equipment that
are removable or directly installed in an I/O module or chassis system. Such devices include
but are not limited to gigabit interface converters (GBICs), small form factor pluggable (SFP)
modules (or mini-GBICs), XENPAK transceivers, and XFP laser optic modules.
WARNING!
Laser optic modules become very hot after prolonged use. Take
care when removing a laser optic module from the chassis or
option card. If the laser optic module is too hot to touch,
disengage the laser optic module and allow it to cool before
removing it completely.
WARNING!
When working with laser optic modules, always take the following
precautions to avoid exposure to hazardous radiation.
Appendix A. Safety Information
| 111
Advertisement
Table of Contents
