Table of Contents
Advertisement
8800 Series 48-port 10/100/1000 Base-T Module XCM8848T
This module has 48 autosensing 10/100/1000BASE-T ports that use standard RJ-45
connectors.
Figure 6. 8800 Series 48-port 10/100/1000 Base-T Module XCM8848T
You can add an optional PoE daughter card (XCM88P) to the 48 G Copper module to provide
Power over Ethernet (PoE) functions in this module. With an installed PoE card, the ports can
deliver PoE to an attached device, as well as the usual Ethernet connection, using a single
cable. The 48 G Copper module supports the IEEE 802.3af PoE specification.
In the default configuration of the XCM8848T module I/O module, all ports:
Are added to the default VLAN as untagged
•
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
•
Operate in autonegotiation mode
•
The XCM8848T module has the following LEDs:
Module status
•
Module diagnostics
•
Port status
•
PoE present
•
For information about the LEDs and their activity on the module, see
page 20.
18 |
Chapter 2. 8800 Series Modules
8800 Series Chassis Switch Hardware Installation Guide
on
I/O Module LEDs
Advertisement
Table of Contents
