Table of Contents
Advertisement
The following figure shows the cable holders and clips being used to manage a group of
cables.
Figure 58. Cable holders and clips
Cable Holders
Each cable holder holds up to 12 separate cables, with 6 on each side. Connect cable
holders end to end as needed to accommodate the number of cables you need to organize.
To connect the cable holders:
Hold two cable holders as shown in
1.
Make sure that one locking tab at the joint is on top and the other is on the bottom.
90 |
Chapter 10. Cable Management
8800 Series Chassis Switch Hardware Installation Guide
Figure
59.
Advertisement
Table of Contents
