Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
Note:
Any unoccupied module slot in the chassis should have a blank
faceplate installed to ensure satisfactory protection from EMI and to maintain
adequate airflow through the chassis.
Remove the module from the antistatic packaging as follows:
4.
a. Place the antistatic bag containing the module on a flat ESD-protective surface that is
clear of any debris.
b. Break the quality seal, the ESD warning seal, and the Read Installation Note seal.
c. Open the antistatic bag and firmly grasp the rail of the module.
d. Hold the rail of the module as you pull the antistatic bag off the module.
Note:
By holding the rail of the module and pulling the ESD bag off the module,
you prevent damage to the module that might be caused by sliding the module
on the ESD surface.
Store the module packaging for future use.
CAUTION:
To prevent ESD damage, hold the module by the metal rail and front panel
only. Never touch the components on the PCB or the pins on any of the
connectors.
Verify that the module injector/ejector handles are open.
5.
Figure 33. Injector/ejector handles in an open position
Keep the injector/ejector handles in the open position as you slide the module into the
6.
chassis slot.
CAUTION:
Do not slide the module into the open chassis slot if the injector/ejector
handles are in the latched position.
Chapter 7. Install Modules and Establish Initial Management Access
| 63
Advertisement
Table of Contents
