Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
Install a PoE Daughter Card XCM88P
The PoE daughter card XCM88P adds PoE functionality to the ports on the XCM8848T
module.
You have to remove the I/O module from the 8800 series switch before you install the PoE
card.
You need the following tools and equipment to install an PoE card:
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
3/8-inch flat-blade screwdriver
•
To install the PoE daughter card XCM88P:
Attach the ESD-preventive wrist strap to your bare wrist. If the metal end is not already
1.
connected, connect it to the ground receptacle at the top left corner of the chassis.
Remove the I/O module from the 8800 series switch, following the instructions in
2.
an XCM8000 Series Module
surface.
Identify the daughter card connectors on the I/O module.
3.
Figure 42. Daughter card connectors on the XCM8848T I/O Module
Remove the PoE card XCM88P from its anti-static packaging.
4.
Align the PoE card with the connectors on the I/O module (see
5.
finger-tighten the retaining screws, starting with the two middle screws.
on page 66. Set the module on an ESD-preventive work
Chapter 8. Install or Remove Cards
Remove
Figure 6, Align and
on page 76).
| 75
Advertisement
Table of Contents
