Using the handle on the option card, pull straight back from the Supervisory module to
5.
disconnect the option card from the connectors on the Supervisory module.
Slide the option card out of the Supervisory module and immediately place it into anti-static
6.
packaging.
If you are installing a replacement option card, install the option card as described in
7.
an Option Card XCM888F in the Supervisory Module
If you are not installing a replacement option card, install the option slot cover plate over
the option card slot.
Re-install the Supervisory module, as described in
8.
page 62.
80 |
Chapter 8. Install or Remove Cards
8800 Series Chassis Switch Hardware Installation Guide
on page 77.
Install an XCM8000 Series Module
Install
on