8800 Series Chassis Switch Hardware Installation Guide
Cable Management
Interlocking cable holders and cable clips for the switches provide free-standing, rigid
structural support for individual cables and cable bundles in front of the switch. You can use
the cable holders and cable clips individually or connect them together to manage multiple
cable bundles.
The cable management accessories keep cables collected in one place, rather than allowing
them to hang freely. If you need to remove a module from the chassis for replacement or
repair, the cable clips and holders maintain the cable arrangement in front of the chassis for
ease of connection when you reinsert the module.
Cable Holders and Cable Clips
When you use the cable holders and the cable clips, NETGEAR recommends the following:
Attach the cables to the holders by slipping the cable through the opening.
•
Connect the cable holders, if you need more than one. (Refer to
•
page 90.)
If you need more than one cable clip for a bundle, connect the clips together before you
•
route the cables through the clips. (Refer to
To form a cable bundle, thread the cables through the clips.
•
Cable Holders
on page 92.)
Cable Clips
Chapter 10. Cable Management
on
| 89