Table of Contents
Advertisement
Model M4500-48XF8C
Fan tray of model M4500-48XF8C
The switch chassis is equipped with six fan trays. Each fan module provides front-to-back
airflow and is hot-swappable. The NETGEAR model number for a fan module is AFT402.
NOTE:
To hot-swap the fan during operation, make sure to replace it within 30 seconds.
Power supply of model M4500-48XF8C
Equipped with two power supply modules (PSUs), the switch can operate with either one or
two PSUs. If the switch uses two PSUs, you can hot-swap one of the PSUs during operation.
The airflow on the PSU from the front to the back.
The AC power connector is a standard three-pronged connector. The switch automatically
adjusts its power setting to any supply voltage in the range from 100~240 VAC at 50~60 Hz.
The NETGEAR model number for a PSU is APS750W.
NOTE:
Verify that each module has the same airflow direction. Make sure the switch runs with all of
its power supply and fan tray modules taking in air from a cold aisle and exhausting air to the
hot aisle.
13 NETGEAR M4500 Series Switches Hardware Installation Guide
Advertisement
Table of Contents
