Chapter 7 Install Modules And Establish Initial Management Access - NETGEAR 8800 Series Hardware Installation Manual

Install Modules and Establish Initial
7.
Management Access
The chapter describes how to install the Supervisory modules and I/O modules in the 8800
series switches and how to set up initial management access for the switch. All module types are
hot-swappable.
The chapter includes the following sections:
• Module Slot Assignments
• Distinguishing a Supervisory Module from an I/O Module
• Install an XCM8000 Series Module
• Connect Network Interface Cables
• Install a Backup Supervisory Module
• Verify the Module Installation
• Remove an XCM8000 Series Module
• Blank Front Panels
• Install or Remove an External Compact Flash Memory Card
• Initial Management Access
Read the information in this chapter thoroughly before you attempt to install or remove an 8800
series Supervisory module or I/O module.
on page 61
on page 62
on page 65
on page 65
on page 65
on page 66
on page 68
on page 72
Chapter 7. Install Modules and Establish Initial Management Access
on page 61
on page 71
7
| 60