Install The Fan Tray; Remove The Fan Tray - NETGEAR M6100 Hardware Installation Manual

Install the Fan Tray


To install the fan tray:
Carefully slide the fan tray all the way into the fan tray bay at the rear of the chassis.
1.
The fan tray is connected to power when it is inserted completely into the fan tray bay.
Screw the fan tray to the rear of the chassis using the included screws.
2.

Remove the Fan Tray

To avoid long periods of operation without forced air cooling, make
Note:
sure that the replacement fan tray is ready before you start the
replacement procedure.

To remove a fan tray from the M6100 series switch chassis:
Locate the captive screws at the top and bottom of the fan tray.
1.
NETGEAR M6100 Switch Chassis
Replace M6100 Series Switch Chassis Components
54