Table of Contents
Advertisement
latches indicate that the module is a Supervisory module, and green injector/ejector release
latches indicate that the module is a I/O module.
Figure 32. Colors on Injector/ejector release latches
Install an XCM8000 Series Module
You need the following tools and equipment to install an XCM8000 series I/O module
or Supervisory module:
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
Appropriate type of cable for any ports on the module
•
When you handle modules, optical devices, or other modular accessories, use an
ESD-preventive wrist strap to reduce the risk of electronic damage to the equipment.
Transport PC boards only in electrostatic packaging. Always place PC boards on a grounded
surface before working on them.
To install a module in a 8800 series switch:
Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle at the top left corner of the chassis.
Select a slot for the module. (See
2.
CAUTION:
Supervisory modules and I/O modules only fit properly into their
designated slots. Forceful insertion into the wrong slot type can damage
the module.
Remove a blank front panel from the chassis slot, if applicable.
3.
62 |
Chapter 7. Install Modules and Establish Initial Management Access
8800 Series Chassis Switch Hardware Installation Guide
Module Slot Assignments
on page 61.)
Advertisement
Table of Contents
