8800 Series Chassis Switch Hardware Installation Guide
Install the 100-240VAC PSU XCM88PS1
CAUTION:
Make sure that the PSU circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install the PSU:
Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle on the top-left corner of the switch front panel.
Verify that the PSU is right side up and the locking handle is open.
2.
Figure 30. PSU with locking handle open
Carefully slide the PSU all the way into the power supply bay (see
3.
PSU into the power supply
CAUTION:
Do not slam the PSU into the system switch backplane. Use the locking
handle to secure the PSU in the power supply bay.
bay).
Chapter 6. Install Power Supply Units in the Switches
Figure 31, Inserting a
| 57