Table of Contents
Advertisement
Safety Information
CAUTION:
Correct lifting procedures for a 8800 series chassis require two or more
people.
Only trained service personnel should perform service to the switches and their components.
Trained service personnel have read all related installation manuals, have the technical
training and experience necessary to be aware of the hazards to which they are exposed in
performing a task, and are aware of measures to minimize the danger to themselves or other
persons.
See
Appendix A, Safety Information
Technical Specifications
certifications.
CAUTION:
Before you lift a 8800 series chassis, make sure the chassis is empty to
prevent unnecessary weight. This will also prevent damage to the system
components due to possible chassis flex when lifting.
Required Tools and Equipment
You need the following tools and equipment to repack a 8800 series chassis:
ESD-preventive wrist strap
•
Support bracket that was shipped with the chassis
•
Four rack-mount screws appropriate to your organization's equipment rack
•
Screwdriver appropriate to the rack-mount screws
•
Original packing materials from the chassis
•
Packing tape
•
Nylon strapping and crimping tool
•
Repack the XCM8810 Chassis
To repack the chassis:
Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle on the chassis front panel.
Remove all modules and power supplies from the chassis. Follow correct procedures for
2.
removing components.
102 |
Chapter 12. Repack an 8800 Series Chassis
8800 Series Chassis Switch Hardware Installation Guide
for additional safety information and
for additional information regarding regulatory compliance
Appendix B,
Advertisement
Table of Contents
