Table of Contents
Advertisement
Never look at the transmit LED/laser through a magnifying device while it is powered
•
on.
Never look directly at a fiber port on the switch or at the ends of a fiber cable when
•
they are powered on.
Invisible laser radiation can occur when the connectors are open. Avoid direct eye
•
exposure to the beam when optical connections are unplugged.
Never alter, modify, or change an optical device in any way other than suggested in
•
this document.
GBIC, SFP (Mini-GBIC), XENPAK, and XFP Regulatory
Compliance
NETGEAR pluggable optical modules meet the following regulatory requirements:
Class 1 Laser Product
•
EN60825-1+A2:2001 or later, European laser standard
•
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
•
Application of CE Mark in accordance with 89/336/EEC EMC and 73/23/EEC Low Voltage
•
Directives
UL and/or CSA registered component for North America
•
47 CFR Part 15, Class A when installed into NETGEAR products
•
NETGEAR optical modules are tested to work in all supported
Note:
NETGEAR switches. We recommend that all customers use
NETGEAR optical modules in their NETGEAR switches. NETGEAR
assumes no liability for third-party optical modules. Although
NETGEARdoes not block third-party optical modules, we cannot
ensure that all third-party optical modules operate properly in all
NETGEAR switches. The customer assumes all risks associated
with using third-party optical modules in NETGEAR switches.
Sicherheitshinweise
WARNING!
Vor der Installation der Produkte von NETGEAR sind die
nachfolgenden Sicherheitshinweise aufmerksam zu lesen. Die
Nichtbeachtung dieser Sicherheitshinweise kann zu Verletzungen
oder Schäden an der Ausrüstung führen.
112 |
Appendix A. Safety Information
8800 Series Chassis Switch Hardware Installation Guide
Advertisement
Table of Contents
