Table of Contents
Advertisement
Verify that the following items are included in the shipping carton:
XCM8810 chassis with eight installed blank front panels
•
Power cord retainer
•
19-inch support bracket
•
Documentation pack with ESD-preventive wrist strap
•
Save all packaging, clip locks, and box pieces for future use in the
Note:
event that the XCM8810 chassis needs to be moved to another
location or returned.
Pre-installation Requirements
The following tools, equipment, and resources are required for installing the 8800 series
chassis:
ESD-preventive wrist strap (provided)
•
19-inch support bracket (provided)
•
Rack-mount screws appropriate for your organization's rack system, as follows:
•
4 screws to attach the support bracket
-
12 screws to secure the chassis in the rack
-
The screw size will vary based on your organization's rack system; screws are not
provided.
Screwdriver appropriate for the rack-mounting screws you will use
•
The screwdriver size depends on the requirements of your organization's rack system.
Rack Mount the 8800 Series Chassis
To mount the 8800 series chassis in a rack:
Locate the 19-inch support bracket that is shipped with the 8800 series chassis.
1.
Identify the rack location where the chassis will be installed.
2.
Using four rack mounting screws, attach the support bracket to the rack immediately below
3.
the chassis location.You need to provide the screws for attaching the support bracket.
48 |
Chapter 5. Install an 8800 Series Chassis
8800 Series Chassis Switch Hardware Installation Guide
Advertisement
Table of Contents
