Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
CAUTION:
Be sure to turn each captive screw only 90 degrees or one-quarter turn
counter-clockwise. Loosening the captive screws beyond 90 degrees will
damage the injector/ejector handles on the module.
Figure 36. Unlocking a module
Figure 37. Indications that the module is unlocked
Squeeze the release latch on each injector/ejector handle and rotate both handles outward
3.
to disconnect the module from the chassis backplane (see
CAUTION:
To prevent ESD damage, hold the module by the metal panel edges only.
Never touch the components on the PCB or the pins on any of the
connectors.
Slide the module out of the chassis slot.
4.
Immediately place the module into the anti-static bag to protect it from potential ESD
5.
damage. The bag will also prevent dust from collecting on the module connectors.
If you are not going to install a replacement module, install a blank front panel. To install a
6.
replacement module, follow the installation procedure.
Chapter 7. Install Modules and Establish Initial Management Access
Figure
37).
| 67
Advertisement
Table of Contents
