Figure 31. Inserting a PSU into the power supply bay
Secure the PSU in the power supply bay by pushing down on the locking handle until it
4.
clicks into place.
If you are replacing a power supply, you do not need to unplug the AC power cord. For a
5.
newly installed power supply, connect the AC power supply cord:
a. If necessary, remove the power cord retainer as described in
Cord Retainers
b. Connect the new AC power cord to the AC input on the front of the switch and to the
wall outlet on the other end. Then re-install the power cord retainer.
c. Re-install the power cord retainer as described in
Retainers
To install additional PSUs, repeat
Leave the ESD strap permanently connected to the switch, so that
Note:
the strap is always available when you need to handle
ESD-sensitive components.
Remove or Replace a PSU
CAUTION:
The PSU may be hot to the touch; use thermal protective gloves when
handling the PSU during removal.
58 |
Chapter 6. Install Power Supply Units in the Switches
8800 Series Chassis Switch Hardware Installation Guide
through
step 2
step
5.
Chapter 9, AC Power
Chapter 9, AC Power Cord