Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
Make sure that each AC power cord is firmly plugged into the power outlet as shown in the
4.
following figure.
Figure 51. Power cord plugged into the XCM8810 Switch power outlet
Align the AC power cord retainer over the AC power cord ends as shown in the following
5.
figure.
Figure 52. Power cord retainer correctly aligned
Tighten the captive screws in the middle and on each end of the power cord retainer (see
6.
the following figure).
Figure 53. Securing the power cord retainer for the 8800 Series Chassis Switch XCM8810
To power the system on, connect the other end of each installed AC power cord to the
7.
power source.
Leave the ESD-preventive wrist strap permanently connected to the
Note:
switch so that it is always available when you need to touch
ESD-sensitive components.
Chapter 9. AC Power Cord Retainers
| 83
Advertisement
Table of Contents
