Managing Components; Adding Component; Deleting A Component; Connecting Component With Multiple Devices - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

8.4 Managing components

Connections with up to four different components can be stored in the app. However, a component can only be
connected to one device at a time.
The following points need to be observed before establishing the connection:
• Bluetooth of the component must be switched on (see Page 40).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned off.
The device must be connected to the internet.
•
• The serial number and Bluetooth PIN of the component being connected must be known. They are found on
the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost, the Bluetooth PIN
can be determined using the adjustment software.

8.4.1 Adding component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the battery charger, in
order to activate recognition (visibility) of the Bluetooth connection for 2 minutes.
4) Tap the Add component button.
→ The Connection Wizard opens and guides you through the process of establishing a connection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This process may take
up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component")
► Add the component again in the Cockpit app (see the section "Adding a component")
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot facing up, or con­
necting and then disconnecting the battery charger), the component can be recognised by another device
(e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long, the process of
establishing a connection is cancelled. In this case, hold the component with the sole of the foot facing up again,
or connect and then disconnect the battery charger.

8.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

8.4.3 Connecting component with multiple devices

The connection for a component can be stored on more than one device. However, only one device can be con­
nected to the component at one time.
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established with the current device:
Genium X3 3B5-3/3B5-3=ST
Cockpit app
symbol appears.
33