Deleting A Component; Connecting Component With Multiple Devices - Otto Bock 17KO1 Series Instructions For Use Manual

4) Tap the "+" button.
→ The Connection Wizard opens and guides you through the process of establishing a connection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This process may take
up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component").
► If present, delete the component from the Bluetooth settings on the device (unpair).
► Rest the component by connecting and disconnecting the battery charger.
► Add the component again in the Cockpit app (see the section "Adding a component").
INFORMATION
After activating the "visibility" of the component (briefly pressing the
by another device (e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long,
the process of establishing a connection is cancelled. In this case the
briefly pressed again.

9.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

9.4.3 Connecting component with multiple devices

The connection for a component can be stored on more than one device. However, only one device can be con­
nected to the component at one time.
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
C-Brace joint unit 17KO1=*
► Tap the OK button.
→ The connection to the last connected device is broken off and estab­
lished with the current device.
OK
symbol appears.
button), the component can be recognised
button on the control panel must be
Cockpit app
35