Deleting A Component; Connecting Component With Multiple Mobile Devices; Use; Movement Patterns In Basic Mode (Mode 1) - Otto Bock Genium X3 Instructions For Use Manual

Use

Only when "DUAL" marking is present (see page 12)
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot facing up, or con­
necting and then disconnecting the battery charger), the component can be recognised by another device
(e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long, the process of
establishing a connection is cancelled. In this case, hold the component with the sole of the foot facing up again,
or connect and then disconnect the battery charger.

8.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

8.4.3 Connecting component with multiple mobile devices

The connection for a component can be stored on more than one mobile device. However, only one mobile device
can be connected to the component at one time.
If there is an existing connection between the component and a different mobile device, the following information
appears while the connection is being established with the current mobile device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
9 Use

9.1 Movement patterns in basic mode (mode 1)

9.1.1 Standing

Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled using the adjustment software. Please see the following
section for further information on the stance function.

9.1.1.1 Stance function

INFORMATION
To use this function, it needs to be enabled in the adjustment software. It also has to be activated using the Cock­
pit app (see page 41).
The stance function (standing mode) is a functional supplement to the basic mode (mode 1). This function makes it
easier, for example, to stand on an inclined surface for a longer time. The joint is fixed in the flexion direction.
This function must be enabled in the adjustment software. Once the function is enabled, you can also choose
between an intuitive and a conscious lock.
36
► Tap the "OK" button.
→ The connection to the last connected mobile device is broken off and
established with the current mobile device.
OK
Genium X3 - Bionic Prosthetic System 3B5-X3/3B5-X3=ST,Ge­
nium X3 3B5-2/3B5-2=ST