Managing Components; Adding Component; Deleting A Component; Connecting Component With Multiple Mobile Devices - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

7.4 Managing components

Connections with up to four different components can be stored in the app. However, a compon­
ent can only be connected to one mobile device at a time.
INFORMATION
Before establishing the connection, observe the points in the section "Initial connection between
Cockpit app and component" (see page 71).

7.4.1 Adding component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the
battery charger, in order to activate recognition (visibility) of the Bluetooth connection for
2 minutes.
4) Tap the "+" button.
→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This
process may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
Delete the component from the Cockpit app if applicable (see the section "Deleting a com­
►
ponent")
Add the component again in the Cockpit app (see the section "Adding a component")
►
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot
facing up, or connecting and then disconnecting the battery charger), the component can be
recognised by another device (e.g. smartphone) within 2 minutes. If registration or establishing
the connection takes too long, the process of establishing a connection is cancelled. In this
case, hold the component with the sole of the foot facing up again, or connect and then discon­
nect the battery charger.

7.4.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

7.4.3 Connecting component with multiple mobile devices

The connection for a component can be stored on more than one mobile device. However, only
one mobile device can be connected to the component at one time.
symbol
73