Deleting A Component; Connecting Component With Multiple Mobile Devices - Otto Bock Kenevo 3C60 Instructions For Use Manual

→ Once the connection has been established, the data are read from the component. This
process may take up to a minute.
The main menu will then appear with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
Delete the component from the Cockpit app if applicable (see the section "Deleting a com­
►
ponent")
Add the component again in the Cockpit app (see the section "Adding a component")
►
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot
facing up, or connecting and then disconnecting the battery charger), the component can be
recognised by another device (e.g. smartphone) within 2 minutes. If registration or establishing
the connection takes too long, the process of establishing a connection is cancelled. In this
case, hold the component with the sole of the foot facing up again, or connect and then discon­
nect the battery charger.

7.3.2 Deleting a component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the symbol under the component you want to delete.
→ The component is deleted.

7.3.3 Connecting component with multiple mobile devices

The connection for a component can be stored on more than one mobile device. However, only
one mobile device can be connected to the component at one time.
If there is an existing connection between the component and a different mobile device, the fol­
lowing information appears while the connection is being established with the current mobile
device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
► Tap the "OK" button.
→ The connection to the last connected mobile device is
broken off and established with the current mobile device.
OK
69